Cisco SPA122 Configuration Guide Version: 1.3.3(015)

All the settings were default on the device before configuration.

Step 1.
Plug all the appropriate wires to your Cisco SPA122 device.
• Ethernet cable [Note: Connect to Ethernet Port on your Cisco SPA122 device and another end to your PC/laptop]
• Phone line (attached to the phone) [Note: Use ‘Phone 1’ port]
• Power

Login page will appear.
Default Username: admin
Default Password: admin

Step 3.
Go to the ‘Network Setup’ tab, then on your left side menu click on ‘Time Settings’ and change the following
settings:
Under ‘Time Zone’ Category choose the appropriate time zone where the Cisco SPA122 is located.
Then click ‘Submit’ button to save changes.
Wait until changes are saved.

Step 4.
Go to the ‘Voice’ tab, then on your left side menu go to ‘SIP’ tile and change the following settings:
Under ‘RTP Parameters’ category
RTP Packet Size: 0.020
Under ‘NAT Support Parameters’ category
NAT Keep Alive Intvl: 20
Then click ‘Submit’ button to save changes.
Wait until changes are saved.

Step 5.
Go to ‘Voice’ tab, then go ‘Regional’ line and change the following settings:
Under ‘Ring and Call Waiting Tone Spec’ category:
Ring Waveform: Sinusoid
Ring Frequency: 52
Ring Voltage: 90
Then click ‘Submit’ button to save changes.
Wait until changes are saved.

Step 6.
Go to ‘Voice’ tab, then go ‘Line 1’ line and change the following settings:
Under ‘NAT Settings’ category:
NAT Mapping Enable: yes
NAT Keep Alive Enable: yes

Under ‘Proxy and Registration’ category:
Proxy: voip.directnet.ca [ Note: ROGERS Internet provider customers – use voip2.directnet.ca:6060 ]
Register Expires: 3600

Under ‘Subscriber Information’ category:
Display Name: [Your first and last name]
[Note: ATA and SIP clients with a Caller ID string containing non-alphanumeric characters will prevent you
from making outgoing calls]
User ID: [Your DirectNet number 1xxxxxxxxxx]
Password: [Your SIP password]

Under ‘Audio Configuration’ category:
Preferred Codec: G711u
Second Preferred Codec: G729a
Third Preferred Codec: G711u
Under ‘Dial Plan’ category:
Dial Plan: (911|[2-9]xxxxxxxxx|1xxxxxxxxxx|011xxxxxxxxxxxx.|98|[6-7]xxxxxxxxxxxx.)
Then click ‘Submit’ button to save changes.
Wait until changes are saved.

Step 8.
Go to ‘Voice’ tab, then click on ‘Line 2’:
Line Enable: no

Then click ‘Submit’ button at the bottom.

Wait until changes are saved.